Video procedure:

Step by step procedure:

This procedure is valid for radio motor:

• Oximo io
• Oximo RTS
• Altus RTS

The following operation must be carried out with individual control point of your roller shutter (remote control or wall-mounted switch).

Double power cut-out

1. Cut-out the power of the concerned drive 2 seconds

2. Turn on the power 8 seconds

3. Cut-out again the power 2 seconds

4. Turn on the power again. The shutter moves for 5 seconds or it makes a brief up and down movement.

Resetting

1. Press and hold the prog button on the back of your control point for 7 seconds until the shutter moves up and down twice.

2. Press up and down at the same time. The shutter makes a brief up and down movement.

Rotation setting

1. Press up to check the rotation. If the drive moves down: Press and hold "my" button 2 seconds until the up and down movement to change the rotation direction

End limit settings

1. Press and hold down to reach the desired lower end limit.

You can press up or down to adjust the position and completely close the shutter

2. Briefly press up and "my" to save the lower end limit, the shutter moves up.

3. Briefly press the "my" button to stop the drive at mid-height position (approximatively)

4. Press and hold up to reach the desired upper end limit.

You can press up or down to adjust the position and completely open the shutter

5. Briefly press down and "my" to save the upper end limit, the shutter moves down.

6. Briefly press the "my" button to stop the drive at mid-height position (approximatively)

7. Press and hold "my" button 2 seconds until the drive moves up and down

8. Briefly press the prog button on the back of your control point. The shutter makes a brief up and down movement.

The roller shutter is set and paired, ready to be used!